cwdutton Posted April 10, 2010 Share Posted April 10, 2010 Hello guys, I have posted this on Benders Battlefield also... Other than Aaron's chart which I have found VERY useful, I was wondering if anyone has a rough estimate on certain steel? I.e- 6x1/4" Brass 6x9/32" Brass 6x1/4" hex brass 6x9/32" hex brass 6x1/4" square brass 6x9/32" square brass 6x5/16" brass 6x11/32" brass Now I'm a newbie at bending, but I do know that steel varies just like grippers, but I've noticed that It's a bit easier to kink brass than Drill Rod,crs, but Brass is a bit more springy. I would appreciate just a rough average where you guys think these pieces fall. My goal is to hit the Golden Bastard soon which Aaron's list puts around 475ish on 7" stock. Put the usual 15% on a 1/2" and you have roughly 546lbs for a piece of 6.5x3/8" brass. Thanks in advance guys! Quote Link to comment Share on other sites More sharing options...
timstruse Posted April 10, 2010 Share Posted April 10, 2010 Hello guys, I have posted this on Benders Battlefield also... Other than Aaron's chart which I have found VERY useful, I was wondering if anyone has a rough estimate on certain steel? I.e- 6x1/4" Brass 6x9/32" Brass 6x1/4" hex brass 6x9/32" hex brass 6x1/4" square brass 6x9/32" square brass 6x5/16" brass 6x11/32" brass Now I'm a newbie at bending, but I do know that steel varies just like grippers, but I've noticed that It's a bit easier to kink brass than Drill Rod,crs, but Brass is a bit more springy. I would appreciate just a rough average where you guys think these pieces fall. My goal is to hit the Golden Bastard soon which Aaron's list puts around 475ish on 7" stock. Put the usual 15% on a 1/2" and you have roughly 546lbs for a piece of 6.5x3/8" brass. Thanks in advance guys! I very recently ordered 6"x3/8" brass from FBBC. I'd compare the kink to regular 6"x5/16" CRS (roughly 620-660#), but the crushdown was much more difficult. I've not calibrated it yet. Quote Link to comment Share on other sites More sharing options...
cwdutton Posted April 11, 2010 Author Share Posted April 11, 2010 Thanks for the reply Tim. Sounds like a pretty NASTY piece of brass! Anyone else have an idea about the pieces listed above? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.