rniel Posted March 28, 2008 Share Posted March 28, 2008 (edited) I know it's crappy video, my head is cutoff for most of it. After bending this one. I went after a 5.5" G5 and could only bend it to 2.5in from the ends tried and tried and then gave it up, but I think when I'm rested better I will do that and more. One thing I should do is mark the center with a pen cause on the 5.5 I did not get the bend started in the middle and it was oblong, seems harder to crush when it's uneven like that. Edited March 28, 2008 by rniel Quote Link to comment Share on other sites More sharing options...
MalachiMcMullen Posted March 28, 2008 Share Posted March 28, 2008 Yeah, much tougher when off-center. This is just the beginning for you Very nice bend Ryan :rock Quote Link to comment Share on other sites More sharing options...
Autolupus Posted March 28, 2008 Share Posted March 28, 2008 Nice bend, you're getting the DO dialled in! Looks like it bent on the thread too so might be a "hard" G5! Quote Link to comment Share on other sites More sharing options...
rniel Posted March 28, 2008 Author Share Posted March 28, 2008 Yeah it did a little. Not sure what Hard G5 means. Does that mean it's tougher than standard. Nice bend, you're getting the DO dialled in! Looks like it bent on the thread too so might be a "hard" G5! Quote Link to comment Share on other sites More sharing options...
knyaz Posted March 28, 2008 Share Posted March 28, 2008 well done, those are some serious bends!!! Quote Link to comment Share on other sites More sharing options...
matthcarl Posted March 28, 2008 Share Posted March 28, 2008 Very nice! Quote Link to comment Share on other sites More sharing options...
crobb1320 Posted March 28, 2008 Share Posted March 28, 2008 Nice job man.you'll be climbing the ladder soon. Quote Link to comment Share on other sites More sharing options...
TravisRush Posted March 28, 2008 Share Posted March 28, 2008 Great job! Quote Link to comment Share on other sites More sharing options...
Bossie 308 Posted March 28, 2008 Share Posted March 28, 2008 Nice Bend Man Congrats Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.